Exhaust - Full System for Yamaha Raptor 700

EASY INSTALLATION REPLACEMENT FOR STOCK EXHAUST, NO CUTTING OR WELDING

• 8 Horsepower Increase (see further details on horsepower gains below)
• 9 ft-lbs Torque Increase at 5,000 rpms
• 105dB at 3,000rpms 110dB at 4,000rpms
• 93dB at 3,000rpms 98dB at 4,000rpms with Quiet Core
• 304SS Hand Polished Pipe
• 14" Muffler w/ Corrugated Steel Wool & Spec 19 Fill
• Exhaust Can in Classic Oval Design
• Comes Standard with a Billet Machined Clamp
• Aluminium Heat Shields

The intent with our Raptor 700 Full Single exhaust was to build a pipe that a very-close-to-stock machine would love. We did not want you to have to really build the machine to take good advantage of the power Yamaha left on the table. We did find that some of the configurations we tested (bigger bore, step pipes, etc…) were able to achieve higher numbers way up in the over-rev but honestly the power just isn’t where you need it. So if you are looking for a rock solid Single Exhaust system that truly performs and puts the power right where you’d want it, this is that exhaust.

Our single exhaust puts the power down low where you need it and really steps up the torque. Looking at the Dyno chart you can see that the torque gains start right away at about 3,800rpms with a 6 ft/lbs gain already and peaking with over 8 ft/lbs gain at 5,000rpms! On the Big Bore Raptor having the gains in the 3-6k rpm range is vital to having a good all-round performing machine.